Takes you to the Home Page This Button will take you to our Products Page for a journey through our product lines. This button will take you to our special listing of our approved dealer near you. This button will take you to a detailed instructions that you can down load. This button will take you to a page that is filled with information that that is good to know. This button will take you to some interesting construction information.  



When our self-contained series will not meet your needs then the WKS split design will provide the flexibility needed to create an ideal installation or deal with unusual site problems. BREEZAIRE WKS Series cooling systems are special split systems that allow mounting of the cooling (evaporator) module in the enclosure to be cooled and the exhaust (condenser) module as far as 100 feet away. The systems are designed - when installed in a properly constructed enclosure - to provide a constant selectable temperature between 48 and 63 degrees Fahrenheit while maintaining 50 to 75 percent relative humidity.

WKS Series systems are designed for easy installation by any, properly equipped, qualified air conditioning or refrigeration service technician. Two copper tubes connect the two modules and power is hard wired to the units using adequately sized 110 AC volt electrical source. These systems must be charged with refrigerant during installation. The WKS series uses BREEZAIRE's rugged adjustable mechanical thermostat.

There are two models to choose from:

BREEZAIRE Model Enclosure Volume Electrical Dimensions (in) Weight
WKS 2200 Fan/Coil 265 cu.ft. 1 Amp 22.00W x 11.00H x 8.00D 25 lb.
WKS 2200 Condenser 265 cu.ft. 4 Amps 14.00W x 10.00H x 12.00D 35 lb.
WKS 4000 Fan/Coil 1000 cu.ft. 1.5 Amps 14.25W x 19.75H x 12.38D 45 lb.
WKS 4000 Condenser 1000 cu.ft. 7.5 Amps 14.25W x 19.75H x 12.38D 55 lb.

Notes:

  1. The WKS 2200 is shipped from the factory with the unit configured with the cold air routed out the front (standard) or out the top of unit (special order).
  2. The WKS 4000 is shipped from the factory with the unit configured with the cold air routed out the front with the option of routing the cold air out the top by the installer.

For more detailed information go to the WKS 2200 Installation Instructions or the WKS 4000 Installation instructions

Copyright © 2002-2005 Breezaire Products Company. All rights reserved. BREEZAIRE Logo and Breezaire are registered trademark of Breezaire Products Company. Unauthorized reproduction, distribution, or use without the consent of Breezaire Products Company may result in severe civil and criminal penalties, and will be prosecuted to the maximum extent possible under California and Federal Trademark and Copyright laws.
Designed and maintained by BREEZAIRE Products